|
基于正反向模拟的板料毛坯设计方法研究
|
|
英文标题：Research on method of blank sheet design based on forward and backward simulation |
|
作者：张燕琴 周泰安 李龙根 |
|
单位：东莞职业技术学院机电工程系 |
|
关键词：毛坯外形设计 反向模拟 正向模拟 |
|
分类号：TG386 |
|
出版年,卷(期):页码：2010,35(1):159-162 |
|
摘要：
|
|
研究了一种冲压毛坯设计方法——基于正、反向模拟的毛坯外形设计技术,该设计方法的主要步骤为:首先测量材料的性能参数,然后采用反向模拟得到初始坯料,最后通过正向模拟进行修正。实际生产表明,该方法克服了经验方法及反向模拟法精度不足的问题,优化设计得到的坯料尺寸精确,只需少量试模即可直接成形无切边的产品,具有很大的经济效益。
|
|
A method of blank design based on forward and backward simulation for designing the blank was researched.The main process steps were as follows: first,the capability parameter of the material was measured;and then initial blank was got from backward simulation;at last,the blank was modified by using forward simulation.The results show that this method has settled the low precision problem in experiential method and backward simulation.Using the accurate blank from optimize design,non-trimming products can be obtained,which has great economic benefits.
|
|
基金项目：
|
|
|
|
作者简介：
|
|
|
|
参考文献：
|
[1]吴建军,张萍.基于板料理想成形的有限元方法研究[J].锻压技术,2008,33(1):131-132.
[2]Chung K,Richmond O.Ideal forming-sheet forming with op-timum deformation[J].International Journal of MechanicScience,1992,34(8):617-633.
[3]周军,马闯,李光耀,等.基于有限元网格映射方法的精确反算求解毛坯[J].机械工程学报,2002,38(12):103-106.
[4]谢慧超,廖代辉,龚英菊.基于滑移约束面方法的毛坯反求技术[J].锻压技术,2008,33(2):134-137.
[5]罗亚军,王静怡,张永清,等.板料成形过程中合理毛坯形状的确定[J].塑性工程学报,2001,8(3):63-66.
[6]Xuchan L,Bingwen L.Modeling of flange deformation of ir-regular drawn cups using a fluid analogy[J].InternationalJournal of Mechanic Science,1986,28(8):491-497.
[7]李顺平,李硕本.盒形件冲压成形的有限元模拟与工艺计算[J].锻压技术,1991,17(6):15-20.
[8]王雪刚,石伟.基于有限元反向法的板料成形毛坯设计[J].塑性工程学报,2004,11(3):64-67.
|
|
服务与反馈：
|
|
【文章下载】【加入收藏】
|
|
|
|
