|
摘要：
|
|
<正> 圆坏压缩试验法是目前广泛地用来研究锻压时润滑效果的一种方法。它可以在接近工作的条件下定量地测定摩擦系数。我所于1978年初,结合几种润滑剂的研究,采用该法使用计算机计算得出了评价摩擦系数的结果,并绘制了比较精确的理论标定曲线。一、圆环压缩试验的理论分析结果在1964年Avitzur(阿维楚)首先发表了圆环压缩时考虑二端面摩擦影响的理想数学解论文[2]。这篇论文是国內一些单位[7、8]所引用的公式来源。之所以称为理想数学解是因为计算时作
|
|
The aim of this investigation is to obtain the accurate calibration curves for Determining friction from the Hot Ring Compression test. However, some errors have been found in comparison fo the theoretical computer solutions to the practical ringtest results. A corrective method is adopted. Mathematical solution of the equations for this calibration was Performed by writing the program in ALGOL 60 and using a DJS-6 Computer
|
|
基金项目：
|
|
|
|
作者简介：
|
|
|
|
参考文献：
|
[1] M.Kunogi, J.Sci, Res.Inst.(Tokyo), 1956, 50215
[2] B.Avitzur, Israel J. of Technology 1964． Vol.2 №3, P.295-304
[3] J.B.Hawkyard and W.Johnson, International J. of Mechanical Sciences, Vol.9 1967 P.163-182
[4] Vincent De Pierre and Fred Gurney, AD744850 1972
[5] A.T.Male and M·G·Cockcroft, J.of Che Inst·of Metals 1964-65,Vol.93 Part2 P·38-46
[6] A·T·Male and V·De Pierre,J.of Lubrication Technology·Trans·of the ASME July, 1970 P.383
[7] 林治平:关于圆环镦粗的数学解及其应用 锻压技术 6期 1980
[8] 林治平 在锻压生产条件下测定塑性变形摩擦系数 第二次锻压学术年会论文 1979
[9] B.Avitzur, F.Sauerwine,J. of engr. for industry Trans. of the ASME, Vol. 100 No.3 1978 P.340-346
[10] B.Avitzur, C. Umana C.J.Van Tyne,Proc. of the 18th Int. Machine Tool Design and Res. Conf. (MTDR) Sept. 1977 P. 305-313
|
|
服务与反馈：
|
|
【本网站尚未开通全文下载服务】【加入收藏】
|
|
|
|
