|
摘要：
|
|
锻模模膛的充填能力是锻模设计的关键,它直接影响锻件的质量及锻模的质量与寿命。本文针对锻模模膛充填困难的特点,以2A12铝合金为研究对象,以棒料模锻后的充填高度为控制目标,采用有限元数值模拟试验,模拟了模锻过程,分析坯料的变形行为,讨论了变形过程中坯料的温度变化情况、整体应力的分布和变化情况。
|
|
The filling capability of forging die is the key to design forging die and it exerts an important influence to the quality and life of die. In response to the difficulty in filling of forging die,and taking 2A12 aluminum alloy as the research object,the bar filling height after forging as the control objective,the finite element numerical simulation method was used to simulate the forging process. This test simulated the process of die forging,analysed the deforming behavior of the stuff and discussed the variety and distribution of temperature and strain。
|
|
基金项目：
|
|
陕西理工学院科研资助项目(SLG0728)
|
|
作者简介：
|
|
|
|
参考文献：
|
[1]柳玉起.板料成形塑性流动规律及起皱破裂回弹的数值研究[D].吉林:吉林工业大学,1995.
[2]吕炎.精密塑性体积成形技术[M].北京:国防工业出版社.
[3]Chung K,Jeong When Yoon,Richmond O.Ideal sheet form-ing with frictional constraints[J].Int.J.Plasticity,2000,(16):595-610.
[4]肖红生,林新波,张质良,等.温锻精密成形技术及其有限元模拟[J].锻压技术,1997,22(6):41-44.
[5]马琳伟,孙乐民,张巧芳.数值模拟锻造成形的关键技术应用[J].金属成形工艺,2003,21(6):17-20.
[6]陈军,彭颖红,阮雪愉.锻造预成形工艺三维塑性有限元模拟[J].锻压机械,1997,(6):41-44.
[7]Oden J T,Pires E B.Non local and nonlinear friction laws and variational principles for contact problems in elasticity[J].Transaction of the ASME Journal of Applied Mechan-ics,1983,(50):67-76.
[8]肖红生,林新波,张质良,等.温锻精密成形技术及其有限元模拟[J].锻压技术,2000,25(2):3-6.
|
|
服务与反馈：
|
|
【文章下载】【加入收藏】
|
|
|
|
