|
摘要：
|
|
提出了一种任意形状截面线的回弹计算理论方法。对任意形状的截面线,根据曲率把截面线分为多个小段;每个小段近似为圆弧,按常规计算回弹的理论方法计算各段的回弹;固定截面上某一点,把回弹后的各小段装配起来,求出整个截面线上的回弹。对某汽车B柱零件上5个截面线上的回弹进行了分析,说明了该方法的可行性。采用该方法,解释了截面上出现负回弹的情况和高强度钢零件扭曲机理。
|
|
A method to analyze springback of arbitrary section was proposed. The section curve was divided into many short sections based on curvature. Every short section was treated as an arc with certain radius. Springback of every arc was then calculated by traditional method. And then fix one point on the section curve,the arc after springback was assembled,thus the springback of the section curve was calculated out. An example to analyze the springback of five section curves of a B-pillar part was provided to verify this method. Negative springback and mechanism of twist were explained by this method.
|
|
基金项目：
|
|
国家杰出青年基金(50625519);;
长江学者和创新团队发展计划资助项目(ITR0718);;
汽车车身先进设计与制造国家重点试验室开放基金(30815008)
|
|
作者简介：
|
|
|
|
参考文献：
|
[1]朱正光,杨晓红.拉弯工艺的数学力学分析[J].锻压技术,2008,32(3):152-154.
[2]李欧卿,梁庆伟,武殿梁,等.板金弯曲成形回弹问题的研究[J].塑性工程学报,2003,10(4):47-54.
[3]朱东波,陈剑虹,李涤尘,等.一种板料弯曲及回弹计算的新方法[J].西安交通大学学报,2000,34(5):64-68,74.
[4]姜银方,袁国定,杨继昌,等.拼焊板弯曲回弹的理论与试验研究[J].机械工程学报,2005,41(12):200-204.
[5]王晓林,周贤宾.金属板弹塑性非圆弧弯曲回弹的计算[J].塑性工程学报,1996,3(4):27-33.
[6]Gerald Farin.CAGD曲线与曲面[M].李双喜,译.北京:科学出版社,2006.
[7]Lee M G,Daeyong Ki m,Spring-back evaluation of automo-tive sheets based on isotropic-kinematic hardening laws and non-quadratic anisotropic yield functions,part III:applica-tions[J].International Journal of Plasticity,2005,(2):915-953.
[8]刘迪辉,钟志华.拉延筋对回弹的影响机理研究[J].中国机械工程,2005,16(20):1876-1879.
|
|
服务与反馈：
|
|
【文章下载】【加入收藏】
|
|
|
|
