|
摘要：
|
|
通过二维建模软件建立管材扩口成形模型,采用大型有限元数值模拟软件对无圆角管材扩口及有圆角管材扩口成形过程进行了数值模拟,获得了其变形材料内部的温度场、应力场、应变场及上模载荷-行程的变化规律。研究结果表明:与无圆角扩口成形相比,有圆角扩口成形具有成形载荷小、应力数值小与应变分布均匀等优点。并进行了相应的工艺实验研究,为有圆角扩口成形技术在工业生产中的应用提供了理论依据。
|
|
A mold of swelling forming process of tubes was built by 2D software,and the swelling forming processes of tubes without round angle and with round angle were simulated based on FEM(Finite Element Method) numerical simulation software.Changing laws of temperature field,stress field,strain field and load-stroke curve of upper die of the deforming material were obtained.The results indicate that the swelling forming with round angle has some advantages,such as smaller loads,smaller stress and well-proportioned strain compared with the swelling forming without round angle.In the meantime,the technology was researched experimentally which provided a theoretical basis for the industrial applications of the swelling forming with round angle technology.
|
|
基金项目：
|
|
国家自然科学基金资助项目(50465003,50765005);;
江西省自然科学基金资助项目(2007GZC1826);;
江西省教育厅资助项目
|
|
作者简介：
|
|
|
|
参考文献：
|
[1]汪大年.金属塑性成形原理[M].北京:机械工业出版社,1986.
[2]王同海,赵国群,贾玉玺.管材冲压扩口变形区的应力应变分析[J].山东工业大学学报,1999,29(3):258-262.
[3]花江,肖颖明,闫洪.管端回转扩口成形研究[J].机械工程学报,1994.30(4):75-78.
[4]梁炳文,胡世光.板料成形塑性理论[M].北京:机械工业出版杜,1987.
[5]中国机械工程学会锻压学会编.锻压手册:2卷冲压[M].2版:北京:机械工业出版社.2002.
[6]田浩彬.板材成形性评定方法的研究及其有限元分析[D].哈尔滨:哈尔滨工业大学,2003.
[7]卢漫宇.由失稳确定的铝管扩口成形极限[J].锻压技术,1997,22(5):34-37.
[8]何涛,王宝雨,胡正寰.偏心圆截面轴类零件的楔横轧成形数值模拟[J].锻压技术,2008,33(1):53-55.
[9]李聚群,杨晓红,姚志英.管材扩径时摩擦对变形状态的影响[J].锻压技术,2008,33(1):133-135.
|
|
服务与反馈：
|
|
【文章下载】【加入收藏】
|
|
|
|
