|
球面形耐热铝合金零件拉深成形工艺研究
|
|
英文标题：Drawing technology of heat-resistance aluminum hemisphere-shaped part |
|
作者：陶友瑞 |
|
单位：湖南工程学院机械工程系 |
|
关键词：包覆拉深工艺 耐热铝合金 曲面形零件 |
|
分类号：TG386.41 |
|
出版年,卷(期):页码：2008,33(5):59-63 |
|
摘要：
|
|
耐热铝合金FVS0812板的成形性能差,拉深成形球面形零件更是困难。本文在实验研究的基础上提出了一种新型的拉深成形工艺,即包覆拉深,采用该工艺成功拉深出相对厚度小的球面形耐热铝合金零件。该工艺可以有效地防止皱曲和破裂的产生,可以使板料的变形均匀分散,从而提高板料的冲压成形性能。包覆拉深工艺是一种适合于低塑性材料拉深成形的工艺方法。
|
|
The formability of FVS0812 sheet is bad and the forming of FVS0812 sphere-shaped part is difficult.Based on experiments,a novel forming technology was presented,named as "packed-layer drawing".A low relative-thickness coefficient sphere-shaped part was drawn successfully by "packed-layer drawing".Both wrinkling and fracturing could be effectively prevented by the technology.The formability of metal-sheet can be improved because the deformation of metal-sheet scattered uniformly."Packed-layer drawing" is fit for the drawing of low plastic metal-sheet.
|
|
基金项目：
|
|
湖南工程学院青年自选课题(2006)资助(120659)
|
|
作者简介：
|
|
|
|
参考文献：
|
[1]Bunk W G J.Alumium RS metallurgy[J].Mater.Sci.Eng.,1991,Al34:1087-1097.
[2]Lavemia E J,Ayers J D,Srivatsan T S.Rapid solidificationprocessing with specific application to aluminum alloys[J].Inter.Mater.Rep.,1991,37(1):1-44.
[3]Vasudevan V K,Fraser H L.The microstructure of rapidlysolidified and heat-treated Al-8Fe-V-Si alloys[J].Mater.Sci.Eng.,1998,88:131-136.
[4]陶友瑞.FVS0812薄板半球形零件拉深成形研究[D].湖南:湖南大学,2004.
[5]李硕本.冲压工艺理论与新技术[M].北京:机械工业出版社,2002.
[6]李硕本.锻压手册:冲压分册[M].北京:机械工业出版社,2002.
[7]汤亚力.快速凝固高温铝合金的显微组织结构及凝固过程研究[D].北京:清华大学,1997.
[8]刑晓冬,郭斌,杨玉英,等.板材粘性压力成形技术研究进展[J].中国机械工程学报,2001,12(2):28-31.
|
|
服务与反馈：
|
|
【文章下载】【加入收藏】
|
|
|
|
