|
摘要：
|
|
对摆动辗压机机身进行力学分析,利用UG软件建立其简化模型并导入有限元分析软件ANSYS中。根据摆动辗压工艺载荷作用点变化的特点,选取载荷作用点不同的3种情况,分别对模型进行有限元分析,得到上、下横梁沿X轴方向及4个立柱中央的应力分布规律,即:上、下横梁沿X轴方向各出现两个应力极值,而各立柱应力分布均为两端应力大、中间应力小。研究结果对摆动辗压机的结构设计具有一定的指导意义。
|
|
The frame of the rotary forging machine was analyzed by mechanics.The simplified model of the rotary forg- ing machine frame was built in UG software and led into the finite element software ANSYS.According to the charac- teristics of the forces applied on the machine,three conditions were chosen to carry on the finite dement analysis and the stress distribution rule of the upper and lower beams along the X axis and the central of the columns were obtained. The stresses of the both beams had two maximum values along the X axis,and the stresses of the columns were small in the middle portion and large at the upper and lower ends.The results are useful for the structural design of the rota- ry forging machine.
|
|
基金项目：
|
|
国家自然科学基金资助重点项目(50335060)
|
|
作者简介：
|
|
|
|
参考文献：
|
[1]郑建荣．ADAMS—虚拟样机技术人门与提高[M]．北京：机械工业出版社，2001．
[2]裴兴华，张猛，胡亚民．摆动辗压[M]．北京：机械工业出版社，1991．
[3]张猛，胡亚民．回转塑性成形模具[M]．武汉：武汉工业大学出版社，1994．
[4]胡亚民．摆动辗压工艺及模具设计[M]．重庆：重庆大学出版社，2001．
[5]张盛华．快锻液压机机架的有限元分析[D]．西安：西北工业大学硕士学位论文，2004．
[6]曾正明．机械工程材料手册．金属材料[M]．北京：机械工业出版社，2003．
|
|
服务与反馈：
|
|
【文章下载】【加入收藏】
|
|
|
|
