|
GIS壳体三通口成形的数值模拟及参数优化
|
|
英文标题：Numerical simulations of GIS shell tee joint forming and its parameter optimization |
|
作者：马永杰 王红卫 侯月玲 |
|
单位：郑州轻工业学院机电工程学院 |
|
关键词：GIS壳体 预开椭圆孔 翻边 正交实验 数值模拟 |
|
分类号：TG386 |
|
出版年,卷(期):页码：2008,33(6):159-162 |
|
摘要：
|
|
采用Dynaform软件,探索GIS壳体三通口在成形过程中压边力、预开椭圆孔长短轴之比、凹模圆角半径和模具间隙对GIS壳体三通口翻边成形的影响规律。应用正交实验方法进行数值模拟,优化三通口冲压成形的模具理想参数和最优拉深工艺参数。把优化参数后的数值模拟的成形厚度变化规律同实验进行比较,两者结果一致,成形后最小厚度提高3.2%。数值模拟结果可以为GIS壳体在实际的生产中提供一定的理论依据。
|
|
Using Dynaform software,the effects of forming parameters such as,forming force,the pre-open hole axis ratio of the ellipse,die fillet radius,die gap etc were explored in GIS shell processing process.Orthogonal experimental approach numerical simulation was used,the optimal parameters of the pre-open hole axis ratio of the ellipse,forming force and die gap etc were gained.The thickness deformation results of numerical simulation and testing were compared.It is shown that the numerical simulation is relatively close to the actual test,the forming minimal thickness is 3.2% higher than before.The simulation result is reliable.It is useful for practical GIS shell forming process.
|
|
基金项目：
|
|
|
|
作者简介：
|
|
|
|
参考文献：
|
[1]黎斌.高压电器设计[M].北京:机械工业出版社,2007.
[2]谭晶,赵振铎,孙胜.非轴对称车灯灯圈成形数值模拟研究[J].塑性工程学报,2001,8(2):17-23.
[3]郭晓甫,王军生,胡新举.六氟化硫断路器壳体孔翻边的工艺计算[J].模具技术,2003,(1):35-36.
[4]李良福.用管坯制造三通管[J].企业技术开发,2001,(1):34.
[5]俞汉清,陈金德编.金属塑性成形原理[M].北京:机械工业出版社,2005.
[6]陈文亮.板料成形CAE分析教程[M].北京:机械工业出版社,2005.
[7]刘振学.实验设计与数据处理[M].北京:化学工业出版社,2005.
[8]辛益军.方差分析与实验设计[M].北京:中国财政经济出版社,2002.
|
|
服务与反馈：
|
|
【文章下载】【加入收藏】
|
|
|
|
