|
摘要：
|
|
汽轮机叶片是将蒸汽能转换成机械功的关键部件,叶片精锻是叶片锻造的发展趋势。本文利用数值模拟方法,仿真了叶片金属在锻模型腔内的流动和成形过程,论述了摩擦条件对叶片精锻成形规律的影响。在锻坯金属变形充模的3个阶段,分析并讨论了不同的界面摩擦因子m对叶片模锻成形规律和模具失效的影响。数值实验结果表明:随着界面摩擦因子的增加,克服坯料金属界面流动阻力所需的附加模锻载荷增加,叶片锻件不同区域内的最大最小温度差、最大最小等效应变差,以及最大最小等效应力差增加;与此同时,锻模型腔局部最大等效应力和最大温度也增加。
|
|
The blade of steam turbine is a key part to change steam energy into mechanical power.Precision forging of blade is the developing tendency of blade forging technology.By means of numerical simulation experiment,the flow and forming process of the blade metal in the cavity of forging die were analyzed.The influence of friction on the forming rules in the precision forging of bade was discussed.Three phases of billet deformation in the forging blade process were emulated and the influence of the different interface friction m on the blade forming rules and the die failure were analyzed and discussed.The experiment results indicate that with the increase of the friction factor m,the accessional die forging load used in overcoming the resistance of the billet-metal flowing on billet-die interface and the differences between the largest and the smallest temperature,equivalent strain and equivalent stress at different areas in the billet section will be increased.At the same time,the local maximum effective stress and temperature in the die cavity will also be increased.
|
|
基金项目：
|
|
|
|
作者简介：
|
|
|
|
参考文献：
|
[1]杨合,詹梅,刘郁丽,等.面向叶片精密成形过程的三维有限元数值模拟技术[J].材料科学与工艺,1999,7(增刊):87-90.
[2]Kong C,Bang J.Structural investigation of composite windturbine blade considering various load cases and fatigue life[J].Energy,2005,30(11-12):2101-2114.
[3]Grass H,Krempaszky C,Werner E.3-D FEM-simulation ofhot forming processes for the production of a connecting rod[J].Computational Materials Science,2006,36(4):480-489.
[4]傅建,彭必友,李军.铝型材挤出速度对模具工作带的影响[J].塑性工程学报,2005,12(3):27-30.
[5]Snape Guy,Clift Sally,Bramley Alan.Parametric sensitivityanalyses for FEA of hot steel forging[J].Journal of Materi-als Processing Technology,2002,1(125-126):353-360.
[6]彭颖红.金属塑性成形仿真技术[M].上海:上海交通大学出版社,1999.
[7]彭建声,秦晓刚.模具技术问答[M].北京:机械工业出版社,2003.
|
|
服务与反馈：
|
|
【文章下载】【加入收藏】
|
|
|
|
