|
摘要：
|
|
在拉深筋成形能力理论、曲面零件变形计算结果、以及实际板料参数这3种条件的基础上,以拉深筋参数设置为重点,应用有限元分析软件Dynaform,分别在有拉深筋和无拉深筋这两种条件下,对曲面零件进行有限元模拟实验。通过模拟实验对比的结果,显示了拉深筋在曲面零件变形时的作用,使理论计算和模拟实验得到了相互验证。同时,也进行了实验验证,实验结果与计算机数值模拟结果相吻合。此方法在整个加工工艺工程中简便直观,对于实际生产有一定的推广应用价值。
|
|
Based on three conditions of draw bead forming theory,distortion calculated result of the curved surface part and the practical plate parameters,the design of curved surface part was simulated stressing on the draw bead parameter setting up by FEA software Dynaform under the conditions of adding draw bead and without draw bead.The draw bead function in deforming the curved surface part was revealed by comparing the simulated results.The theoretical calculation and simulated experiment were proved with each other.At the same time,the experiment validation was made.The results show that the numerical simulation result is consistent well with that of the experiment.This method is simple and intuitionistic in the whole course of machining process.It has a popularized application value for practical production.
|
|
基金项目：
|
|
|
|
作者简介：
|
|
|
|
参考文献：
|
[1]王志恒,张晶,段瑞刚,等.影响拉深筋结构及应用的因素分析[J].锻压技术,1997,22(2):20-24.
[2]刘建华,丁国,王志恒.内皱发生的临界计算及校核条件[J].锻压技术.2000,25(2):28-32.
[3]陈文亮.板料成形CAE分析教程[M].北京:机械工业出版社,2005.
[4]张士宏,尚彦凌,郎利辉,等.用动态显示有限元法对板料成形进行计算机模拟[J].塑性工程学报.2001,8(3):19-24.
[5]林启权,宁智群,赵雄.椭圆盒拉深成形的数值模拟[J].湘潭大学自然科学学报.2005,27(2):136-141.
[6]赵升吨,杨玉海,王骥.筒形件新型充液拉深的数值模拟及工艺机理分析[J].塑性工程学报,2003,10(1):65-70.
[7]吴伯杰,黄祥煜,谷志飞.热水器封头零件拉深工艺研究[J].塑性工程学报,2005,12(2):26-29.
[8]黄祥煜,吴伯杰,曾攀.薄壁紫铜零件多次拉深成形的数值模拟[J].锻压技术,2005,30(1):16-18.
|
|
服务与反馈：
|
|
【文章下载】【加入收藏】
|
|
|
|
