|
摘要：
|
|
磁脉冲冲孔是一种高能率成形方式,特别适合于薄板加工。采用试验的方法,在3种不同成形方式下,研究放电电压对冲孔成形性能的影响。研究结果表明:冲孔所需最小成形电压随着板料厚度的增加而增加;对于同一厚度的铝板,当电压大于最小冲孔电压时,电压越大,断面质量越好;在3种成形方式中,板坯上下放置弹性传压介质的成形方式毛刺区域最小,断面质量最佳,但所需能量最大。
|
|
Magnetic pulse piercing is a kind of high energy rate forming technology and can be applied in thin plank forming specially.Under three different forming modes,the effect of discharge voltage on piercing property is analyzed.The experimental results indicate that the minimum discharge voltage of piercing ascents with the increasing of blank thickness and cross section quality is better when the discharge voltage is higher than the minimum discharge voltage under the same blank thickness.At the same time,among the three modes,when the blank is placed between elastic mediums,the burr area is of minimum and the cross section quality is the best,but the energy is of maximum.
|
|
基金项目：
|
|
|
|
作者简介：
|
|
|
|
参考文献：
|
[1]李硕本.冲压工艺学[M].北京:机械工业出版社,1983.
[2]高能成形编写组.高能成形[M].北京:国防工业出版社,1969.
[3]李春峰.高能率成形技术[M].北京:国防工业出版社,2001.
[4]初红艳,潘风文,费仁元,等.电磁冲裁成形与普通冲裁成形的分析与比较[J].锻压技术,2001,(1):28 30.
[5]刘全胜,黄尚宇,常志华.强磁脉冲力作用下板材的断裂模式研究[J].锻压技术,2002,(1):45 47.
[6]Zhang X,Wang Z R,Song F M,et al.Finite element si mulation ofthe electromagnetic piercing of sheet metal[J].Journal of MaterialsProcessing Technology,2004,151:350 354.
|
|
服务与反馈：
|
|
【文章下载】【加入收藏】
|
|
|
|
