|
摘要：
|
|
对矩形抛物面反光罩的充液成形进行研究,探讨该零件充液成形的变形特点。对工件成形过程中出现的破裂现象进行了分析,按成形中破裂发生的位置和变形阶段分5种情况对破裂的成因进行研究,结果表明,液体压力控制方式、压边力的大小以及初期液体压力的加载方式是影响破裂的主要因素。最后通过实验成形出合格零件,获得了大拉深比矩形抛物面反光罩的成形曲线。
|
|
This paper deals with the hydroforming of square parabolic reflector. The deformation mechanics of square parabolic reflector with hydroforming is revealed. The factures occurred on forming process is studied. it has been classified in five types based on the fracture position and the stroke phases, and the mechanics of fracture is analyzed. It has been observed that the initial stage of hydraulic pressure, the blank holding force and the control mode of hydraulic pressure are key factors to prevent fractures. The required specimens were manufactured successfully and larger drawing ratio curves of hydroforming are obtained by experiments.
|
|
基金项目：
|
|
河北省自然科学基金资助项目(598265)
|
|
作者简介：
|
|
|
|
参考文献：
|
[1] 中村和彦,中川威雄.注目されゐ对向液压成形法の应用と各種實例[J].プレス技術,1981,60:919.
[2] 中村和彦.对向液压付加にょる深絞リ限界の向上策[J].塑性と加工,1986,27:300.
[3] 王保华.矩形抛物线车灯反光镜充液拉深实验研究[D].秦皇岛:燕山大学,2002.
[4] 张海明,董湘怀,李尚健,李志刚.汽车前照灯矩形反光镜拉深成形过程有限元模拟[J].锻压技术,2001,26(3):1518.
[5] 肖红林.奥托轿车前大灯反光镜拉深工艺计算及模具设计[J].金属成形工艺,1994,12(6):257262.
|
|
服务与反馈：
|
|
【文章下载】【加入收藏】
|
|
|
|
