|
摘要：
|
|
采用双辊夹持扩旋成形新工艺来加工风机机壳零件,利用ABAQUS软件建立了风机机壳双辊夹持扩径旋压成形过程的三维有限元模型,并利用该模型进行了风机机壳扩径旋压成形过程的数值模拟。获得了成形过程中等效应力、应变及壁厚的分布,并对旋辊进给率对成形件应力应变及壁厚差的影响规律进行了研究。结果表明,等效应力、应变随着旋辊进给率的增大而减小,而最大壁厚差随着旋辊进给率的增大而增大。最后综合考虑得到旋辊进给率的建议取值为0.16 rad.r-1。
|
|
New double rollers clamping expanding spinning process was adopted to manufacture the fan casing,and using FE simulation code ABAQUS/Explicit,the 3D simulation model of expanding spinning process for fan casing was built,and the spinning process and material deformation were simulated.Distribution of equivalent stress,equivalent strain and wall thickness of fan casing were obtained.And then effects of roller feed rate on the stress,strain and wall thickness difference of formed fan casing were studied.Results show that equivalent stress and equivalent strain decrease with the increase of roller feed rate,while maximum wall thickness difference increases with the increase of roller feed rate.Comprehensive consideration suggests that the value of roller feed rate should be 0.16 rad·r-1.
|
|
基金项目：
|
|
国家自然科学基金资助项目(50905137);;
科技人员服务企业行动项目(2009GJG00029)
|
|
作者简介：
|
|
|
|
参考文献：
|
[1]朱宏祥.大型集风器旋压机[J].中国科技成果,1999,(18):43-44.
[2]Xu Y,Zhang S H,Li P,et al.3D rigid-plastic FEM numeri-cal simulation on tube spinning[J].Journal of Materials Pro-cessing Technology,2001,113(1-3):710-713.
[3]Hua F A,Yang Y S,Zhang Y N,et al.Three-dimensionalfinite element analysis of tube spinning[J].Journal of Mate-rials Processing Technology,2005,168(1):68-74.
[4]Bai Qian,Yang He,Zhan Mei.Finite element modeling ofpower spinning of thin-walled shell with hoop inner rib[J].Transactions of Nonferrous Metals Society of China,2008,18(1):6-13.
[5]Quigley E,Monaghan J.The finite element modeling of con-ventional spinning using multi-domain models[J].Journal ofMaterials Processing Technology,2002,124(3):360-365.
[6]Liu Chun h.The simulation of the multi-pass and die-lessspinning process[J].Journal of Materials Processing Tech-nology,2007,192-193:518-524.
[7]Xia Q X,Xie S W,Huo Y L,et al.Numerical simulationand experimental research on the multi-pass neck-spinning ofnon-axisymmetric offset tube[J].Journal of Materials Pro-cessing Technology,2008,206(1-3):500-508.
|
|
服务与反馈：
|
|
【文章下载】【加入收藏】
|
|
|
|
