|
摘要：
|
|
采用实验研究和有限元分析相结合的方法,研究了3种轴类件(实心件、空心件、带芯棒的空心件)在三辊楔横轧过程中轧件的内部缺陷。研究结果表明:实心件心部附近的环状区域易产生明显裂纹,而空心件能够有效的避开环状缺陷;方向交变的剪应力促使轧件心部附近孕育微观破坏,拉应力促进裂纹进一步扩展。实验采用带芯棒的空心件轧制,能够制备出高质量的轴件,为丰富三辊楔横轧加工理论及扩大应用范围提供理论依据与实验支持。
|
|
The research on the interior defects in three types of rolled shafts(such as solid part,hollow part,hollow part with mandrel) during three-roll cross wedge rolling(CWR) was researched.The results show that there is a ring zone with the distinct crack near the center of solid part,the ring defects are effectively avoided in the hollow part.Finite element analysis based on the experiment was carried out.Its results show that alternating shear stress is the first cause to the ring rarefaction defect at work piece's centre,pulling stress can promote the crack growth.The product quality for hollow shaft with mandrel is the best.The investigation can provide theoretical and experimental foundation for enriching the theory of 3-roll CWR and its application scope.
|
|
基金项目：
|
|
国家自然科学基金资助项目(50075076,50705080);;
北华航天工业学院科研基金资助项目(KY-2008-03-B)
|
|
作者简介：
|
|
|
|
参考文献：
|
[1]胡正寰,张康生,王宝雨,等.楔横轧成形技术与模拟技术[M].北京:冶金工业出版社,2004.
[2]团野敦,粟野泰吉.段付き轴转造时の中心穴登に及ぽす转造条件の影响[J].塑性と加工,1976,17:117-123.
[3]叶山益次郎.段付き棒のクロスロ-ル加工の最适加工条件[J].塑性と加工,1976,17:797-804.
[4]蔡亚宁,张康生,娄依志,等.成形角对楔横轧二次楔轧制心部缺陷的影响[J].锻压技术,2008,33(3):68-71.
[5]采利科夫.轧制原理手册[M].王克智,译.北京:冶金工业出版社,1989.
[6]赵志业.金属塑性变形与轧制理论[M].北京:冶金工业出版社,1980.
[7]杨翠苹,张康生,刘晋平,等.三辊楔横轧应力应变场对内部缺陷的影响[J].北京科技大学学报,2006,28(5):464-467.
[8]胡正寰,许协和,沙德元.斜轧与楔横轧原理、工艺及设备[M].北京:冶金工业出版社,1985.
|
|
服务与反馈：
|
|
【文章下载】【加入收藏】
|
|
|
|
