|
摘要：
|
|
挤压后的零件不易脱模是多台阶空心零件在挤压成形工艺中的难点。本文介绍了采用分合模机构的挤压工艺,即合模时挤压工件,分模时再顶出。在分析多台阶空心件挤压工艺基础上,运用有限元软件DEFORM对圆台和圆柱两种合适形状毛坯的挤压全过程进行了模拟,分40,55,278,500这4个特征时间步进行分析,得出了金属的流动规律并找到圆柱形是最优的毛坯形状,另外还得到了各个挤压工步的载荷-行程曲线以及侧向胀模力曲线,以便对模具及各种成形参数进行优化。最后按照模拟的工艺参数进行了实验,得出了符合要求的工件。
|
|
The forming of hollow steps shaped part by the extrusion forming process is a difficult problem.The law of metal flow can not be clearly understood,and the formed part also can not be easily taken out.A new method which adopts clamping device was introduced.The part was formed when device folds,while taken out when device unfolds.Based on the analysis of hollow steps part extrusion,the entire process simulation of tow kinds stock extrusions were carried out using finite element software DEFORM,in 4 time steps of 40,55,278,500.The law of metal flow was obtained,and found out the column was the best shape for stock.Moreover,the load-stroke curve for all steps and X-load curve were achieved in order to optimize the mold forming parameters.Finally the experiment was done according to the parameters of simulation and qualified part was obtained.
|
|
基金项目：
|
|
湖北省科委科技攻关计划项目(2005AA101C36)
|
|
作者简介：
|
|
|
|
参考文献：
|
[1]王大勇,田孝飞.端子冷挤压工艺及模具设计研究[J].锻压技术,2006,31(5):107-109.
[2]贾俐俐.挤压工艺及模具[M].北京:机械工业出版社,2004.
[3]洪慎章.冷挤压实用技术[M].北京:机械工业出版社,2005.
[4]翟德梅.挤压工艺及模具[M].北京:化学工业出版社,2004.
[5]王华昌,王冠,龙满林,等.塑性加工中的一种广义有限元方法[J].哈尔滨工业大学学报,2003,35(1):21-24.
[6]欧阳资恩,胡蓉.REV100注塑-吹塑机合模机构设计分析[J].塑料科技,2007,35(4):66-69.
[7]宋蓓莉,石端伟,朱惠华,等.RD400C冷室压铸机合模机构的设计及有限元分析[J].铸造技术,2004,25(8):631-633.
[8]彭巍,赵玉民,杨金娥.车用发电机磁极的精密成形技术[J].模具制造,2006,(3):23-25.
|
|
服务与反馈：
|
|
【文章下载】【加入收藏】
|
|
|
|
