|
摘要：
|
|
为了分析电磁铆接电磁场的变化规律,采用数值模拟方法,以ANSYS软件为平台建立了电压激励的电磁场耦合模型。通过电阻分流器测量线圈放电电流,验证建立耦合模型的正确性。研究结果表明:驱动片主要受轴向磁场力作用,沿驱动片径向分布不均匀,在驱动片半径一半附近轴向磁场力最大;磁场力沿驱动片厚度方向呈梯度分布。在线圈与驱动片之间,磁场主要沿径向分布,渗入驱动片的磁场呈衰减分布。
|
|
In order to analyze the change law of electromagnetic field on electromagnetic riveting process,numerical simulation method was used to establish the electromagnetic field coupling model which was a voltage source by ANSYS.Through measuring the discharge current of the coil with diverter,the coupling model was proved to be doable.The simulation results show that the drive plate is mainly subjected to axial magnetic force,whose distribution is non-uniform along the radial direction of the drive plate,and the maximum value of axial magnetic force locates in about half of the drive plate radius.At the same time,the magnetic force along the driver plate thickness is a gradient distribution.Between the coil and drive plate,the magnetic field is mainly radial and the infiltration magnetic field is an attenuation distribution.
|
|
基金项目：
|
|
福州大学人才基金项目(826634)
|
|
作者简介：
|
|
|
|
参考文献：
|
[1]李春峰.高能率成形技术[M].北京:国防工业出版社,2001.
[2]Zieve P B.Low voltage electromagnetic riveter[D].Seattle:University of Washington,1986.
[3]Reinhall P G,Ghassaei S,Choo V.An analysis of rivet diesdesign in electromagnetic riveting[J].Journal of Vibration,Acoustics,Stress and Reliability in Design,1988,110:65-69.
[4]Choo V,Reinhall P G,Ghassaei S.Effect of high rate de-formation induced precipitation hardening on the failure alumi-num rivets[J].Journal of Materials Science,1989,24:599-608.
[5]Hartmann J.Development of the handheld low voltage elec-tromagnetic riveter[J].SAE Transactions,1990,99(1):2371-2385.
[6]邓将华,李春峰.电磁铆接技术研究概况及发展趋势[J].锻压技术,2006,31(5):10-14.
[7]曹增强,刘洪.电磁铆接技术[J].塑性工程学报,2007,14(1):120-123.
[8]Cao Z Q,Cardew-Hall M.Interference-fit riveting techniquein fiber composite laminates[J].Aerospace Science andTechnology,2006,10(4):327-330.
[9]曹增强.电磁铆接理论及应用研究[D].西安:西北工业大学,1999.
[10]雷银照.轴对称线圈磁场计算[M].北京:中国计量出版社,1991.
[11]阎照文.ANSYS 10.0工程电磁分析技术与实例详解[M].北京:中国水利水电出版社,2006.
[12]赵志衡.管坯电磁胀形磁场力的研究[D].哈尔滨:哈尔滨工业大学,2001.
[13]Li C F,Zhao Z H.Numerical simulation of the magneticpressure in tube electromagnetic bulging[J].Journal of Ma-terials Processing Technology,2002,123(2):225-228.
[14]Yu H P,Li C F,Zhao Z H.Effect of field shaper on mag-netic pressure in electromagnetic forming[J].Journal of Ma-terials Processing Technology,2005,168(2):245-249.
[15]张守彬.电磁成形胀管过程的研究及工程计算方法[D].哈尔滨:哈尔滨工业大学,1990.
|
|
服务与反馈：
|
|
【文章下载】【加入收藏】
|
|
|
|
