|
摘要：
|
|
采用弹塑性变形理论分析了紫铜三通管轴压胀形过程中单位胀形力、轴向载荷及平衡力的计算,分析了支管平衡力对成形质量的影响,制定了胀形过程的轴压进给量;建立三通管轴压胀形三维弹塑性有限元模型,分析成形工艺特点,获取合理的工艺参数和模具结构;然后在自行研制的30 t轴压胀形试验机上进行工艺试验验证,并对试件进行分析。结果表明,理论分析、有限元数值模拟和试验结果相吻合。
|
|
Based on the theory of plasticity,the internal pressure,axial force and balance force of bulging in the copper tri-branch tube forming process were studied.The influence of balance force in branch tube was analyzed and the axial feed was obtained.The finite element model of axial force and bulging process for copper tri-branch tube was set up.Through the simulation the reasonable parameters and die structure were found.According to the reasonable parameters experiment was done in the independently-established 30 ton test machine.The result shows that experiment consistent with theory analysis and numerical simulation.
|
|
基金项目：
|
|
|
|
作者简介：
|
|
|
|
参考文献：
|
[1]李新军,周贤宾,郎利辉.薄壁管轴压胀形关键工艺参数及成形极限[J].北京航空航天大学学报,2006,32(4):475-480.
[2]Ahmetoglu M,Altan T.Tube hydroforming:state-of-the-artand future trends[J].Journal of Materials Processing Tech-nology,2000,(98):25-33.
[3]Dohmann F,Hartl Ch.Tube hydroforming research and prac-tical application[J].Journal of Materials Processing Technol-ogy,1997,(71):174-186.
[4]Ray P,Mac Donald B J.Experimental study and finite ele-ment analysis of simple X-and T-branch tube hydroformingprocesses[J].International Journal of Mechanical Sciences,2005,(47):1498-1518
[5]张彦敏,宋志真,孙爱学.弹、塑性传力介质下三通管轴压胀形工艺分析[J].塑性工程学报,2008,15(69):136-139.
[6]高凤玲,赵伟,孙爱学,等.等径三通管复合胀形工艺及试验研究[J].热加工工艺,2003,(6):19-20,64.
[7]王同海.管材塑性加工技术[M].北京:机械工业工业出版社,1998.
|
|
服务与反馈：
|
|
【文章下载】【加入收藏】
|
|
|
|
