|
摘要：
|
|
运用DYNAFORM有限元数值模拟分析软件,对汽车转向柱后支架的弯曲成形进行了数值模拟。结果表明,一次成形在弯曲处有严重的变薄现象,两次成形无论是应力分布还是厚度分布都优于一次成形,所以采用两步弯曲成形的工艺方案。同时,设计了多工位弯曲模具,即将支架的两套弯曲模安装在同一模架上,在冲床的一次行程中完成支架的弯曲成形。这样避免了在一套弯曲模上一次成形产生的缺陷,同时解决了用两套模具单工序成形效率低的问题。
|
|
FEM analysis software of DYNAFORM was used to simulate the bending form for the support.The result showed that serious thinning was found in one die forming,and the distribution of stress and thickness of forming in two sets of dies are better than those in one die forming.So the bending forming in two sets of dies for support was determined.At the same time,the progressive bending die was designed.Two sets of bending dies for the support were fixed on one die carrier,so bending forming for the support was finished in one running distance.Then,the disadvantages of forming in one operation were avoided,and the low efficiency problem was also solved with single process.
|
|
基金项目：
|
|
|
|
作者简介：
|
|
|
|
参考文献：
|
[1]姜奎华.冲压工艺与模具设计[M].北京:机械工业出版社,1999.
[2]谭雪松,谢正超.Pro/ENGINEER2001中文版基础教程[M].北京:人民邮电出版社,2003.
[3]杨太德.支架冲压工艺与模具设计[J].锻压技术,2007,32(5):101-102.
[4]董兰,田福祥.杠杆式弯曲模[J].锻压技术,2006,31(4):73-74.
[5]刘林强,田福祥.DYNAFORM-PC软件简介及使用技巧[J].锻造与冲压,2004,(3):16-18.
[6]岳陆游,姜银方,陈炜,等.DYNAFORM-PC软件及其在钣金冲压中的应用[J].江苏大学学报(自然科学版),2002,23(11):51-55.
|
|
服务与反馈：
|
|
【文章下载】【加入收藏】
|
|
|
|
