|
摘要：
|
|
冷辗扩过程中,轧辊和环件接触面积小、振动剧烈,进行显式有限元分析时形成的单点载荷容易诱发沙漏。采用组合沙漏控制法有效地控制了沙漏,模拟了矩形截面环件的冷辗扩过程。沙漏能与内能的比值从阻尼法的15%降低到2.5%;其中刚度沙漏力的权系数设为0.8,人工阻尼控制系数设为0.1,人工刚度控制系数设为0.001。与轴向宽展试验比较表明,采用组合法预测的端面平整度(0.114)接近试验结果(0.112)。
|
|
In explicit finite element analysis of cold ring rolling process,hourglass was easily aroused by one point load because of violent vibration and small contact area between rollers and ring.Combined hourglass control method was adopted to control the hourglass effectively.The cold rolling process of the ring with rectangular section was simula- ted.The ratio of hourglass energy to internal energy with combined method was reduced from 15% with damping method to 2.5%.The weight factor of artificial stiffness hourglass resistance was 0.8.The artificial damping hour- glass control coefficient was set to 0.1,and the artificial damping hourglass control coefficient was set to 0.001.Com- pared with the experiment of axial broadening,the result shows that the axial edge flatness(0.114)predicted with combined method is close to the experiment result(0.112).
|
|
基金项目：
|
|
国家自然科学基金重点项目(50335060)
|
|
作者简介：
|
|
|
|
参考文献：
|
[1]华林，黄兴高，朱东春．环件轧制理论和技术[M]．北京；
机械工业出版社，2001．
[2]许思广，曹起骧，连家创．环件轧制中晶粒变化的计算机模拟[J]．塑性工程学报，1994，1(2)：24-30．
[3]罗洲，华林，周勇强．环件轧制过程的显式有限元模拟分析[J]．塑性工程学报，2004，11(1)：68-70．
[4]Yang H,Guo L G,Zhan M,etc.Research on the influence of material properties on cold ring rolling processes by 3D-FE numerical simulation[J].J.of Materials Processing Tech- nology,2006,177(3):634-638.
[5]华林，潘利波，兰箭，等．大型环件的径轴向轧制工艺模拟和研究[J]．中国机械工程，2006，17(19)：2020-2023，2071．
[6]John O Hallquist.LS-DYNA theoretical manual[M].Liver- more Software Tech.Corp,1998.
[7]Flanagan D P,Belytschko T.A uniform strain hexahedron and quadrilateral with orthogonal hourglass control[J].Int.J. Numer.Methods Engrg,1981,17:679-706.
[8]左治江．环件冷辗扩成形规律和工艺模拟[D]．武汉：武汉理工大学，2006．
|
|
服务与反馈：
|
|
【文章下载】【加入收藏】
|
|
|
|
