锻压技术

压料面形式对矩形盒拉深成形影响的数值模拟

英文标题：Numerical simulation of the influence on rectangular case drawing deformation based on different blank-holder surface form

作者：魏乐愚鄂大辛

单位：北京理工大学机械与车辆工程学院北京理工大学机械与车辆工程学院北京100081 北京100081

关键词：压料面非回转对称数值模拟矩形盒

分类号：TG386.3

出版年,卷(期):页码：2006,31(3):39-42

摘要：

针对3种压料面形式下矩形盒的拉深成形过程进行数值模拟,得出相应板坯曲边的剪切应力及角对称线上等效应力、等效应变的分布规律,并对其进行了对比分析。模拟结果表明矩形盒法兰曲边采用锥面压料面形式时的成形性能最好,板坯整体变形最均匀;采用柱面压料时成形极限比平面压料时更低。该研究结果对非回转对称拉深的试验研究及实际生产具有一定的参考价值。

The numerical simulation concerning rectangular case drawing process at three different kinds of curve face blank-holder is carried out,from which distribution of shearing stress in the region of flange curve edge as well as that of equivalent stress and equivalent strain on the symmetric line of round angle are obtained.Furthermore,a comparative analysis is conducted.The simulation result shows that the best forming property and evenest overall deformation of the blank can be gotten when rectangular case is based on pyramidal surface in the region of flange curve edge,and that forming limit based on cylindrical surface is lower than that based on plane surface.This research possesses considerable value for the experimental study on rectangular case drawing as well as practical work.

基金项目：

参考文献：

[1]鄂大辛,庞愉平,水野高尔.非回转对称拉深中法兰材料变形规律的研究[J].中国机械工程,2004,15(5):462464.
[2]鄂大辛,水野高尔.非回转对称拉深中材料流动变形规律的研究机[J].机械工程学报,2003,39(4):49 52.
[3]徐伟力,郭刚,李雪春,等.柱面压料面形式对矩形盒件拉深成形的影响[J].塑性工程学报,1998,5(2):45 49.
[4]杨玉英,徐伟力,邢忠文.球面压料面对方盒件成形的影响[J].塑性工程学报,1997,4(3):28 32.
[5]杨玉英.盒形件成形机理的探讨[J].锻压技术,1989,(6):13 17.
[6]文涛,鄂大辛.矩形拉深件材料流动变形规律的有限元分析[J].现代制造工程,2004,(4):40 42.

服务与反馈：

【文章下载】【加入收藏】