|
摘要：
|
|
根据剪旋过程的实际情况进行了应力应变分析 ,对剪旋变形机理提出了新的见解 ,将剪旋变形区分为拉弯区和辗压变形区。前者的受力情况类似于胀形 ,后者为母线方向拉应力作用下的辗压变形 ,该区起主要减薄壁厚的作用。此外 ,本文利用Z形图对剪旋的各种状态进行了应力应变分析 ,并确定出了剪旋时最佳应力应变状态的区域。
|
|
According to the deformation of shear spinning on conical workpieces,the stress and strain has been analyzed and the new deformation mechanism has been put forward that the forming area of shear spinning should be divided into tension bending zone and rolling zone. The former is similar to bulge, but the deforming mode of the latter is rolling in which the stress is tensile in generatrix direction and the wall thickness are mainly reduced in this zone. In addition, by means of Z graph,the stress and strain of different shear spinning state has been researched and the optimum range of stress and strain has been gained.
|
|
基金项目：
|
|
|
|
作者简介：
|
|
|
|
参考文献：
|
1 梁炳文,胡世光板料成形塑性理论.北京:机械工业出版社,1987.
2 陈敬之译,陈适先校,日本塑性加工学会.旋压成形技术,北京:机械工业出版社,1988.
3 SKalpakcioglu.AExperimentalStudyofPlasticDeformationinPowerSpin.CIRPAnnalen10-1,1961.
4 KobayashiS .,IKHall,EGThomson.ATheoryofShearSpinofCones.Trans.ofASME ,SeriesB ,83,1961.
5 王成和,刘克璋旋压技术北京:机械工业出版社,1986.
6 MB斯德洛日夫,EA波波夫金属压力加工原理北京:机械工业出版社,1980.
7 吕炎等锻压成性理论与工艺北京:机械工业出版社,1995.
8 王仲仁,李守栋等论屈服轨迹上的应力分区及其与塑性成形时工件尺寸的对应关系金属学报,1982
9 王德林,刘东小锥角超长铝锥的旋压工艺研究.第五届全国旋压技术交流会论文汇编,1990:45～49
10 李茂盛旋压工艺参数对锥形件质量影响的试验第五届全国旋压技术交流会论文汇编,1990:18～22
|
|
服务与反馈：
|
|
【文章下载】【加入收藏】
|
|
|
|
