|
Abstract：
|
|
The principle of NC incremental sheet metal forming and the forming process of the fender were introduced.The effect of process parameters on forming was analysed.The improvement method of the forming quality was suggested.The forming tool radius r and feed pitch h were the main process parameters in NC incremental forming of fender.Considering the interference,the larger forming tool radius r(r=5 mm) is advantageous to forming.The feed pitch h should be as small as possible in order to improve the surface quality and to make the deformation more uniform.But the forming efficiency shall be very low if feed pitch is too small.In general,the feed pitch of 0.25 mm is good.
|
|
Funds：
|
|
江西省教育厅课题(GJJ10285)
|
|
AuthorIntro：
|
|
|
|
Reference：
|
[1]Matsubara S.A computer numerically controlled dieless in-cremental forming of a sheet metal[J].Journal of Engineer-ing Manufacture,2001,215:959-966.
[2]Park J J,Kim Y H.Fundamental studies on the incrementalsheet metal forming technique[J].Journal of Materials Pro-cessing Technology,2003,140:447-453.
[3]周六如.金属板料数控渐进成形机理及工艺的研究[D].武汉:华中科技大学,2004.
[4]周六如.金属板料数控渐进成形的变形机理研究[J].现代机械,2008,(增刊):75-76.
[5]周六如.基于数控渐进成形技术的方形盒成形工艺[J].锻压技术,2009,34(4):65-68.
[6]周六如,肖祥芷,莫健华.金属直壁筒形件数控渐进成形工艺研究[J].机械科学与技术,2004,(11):1366-1369.
[7]周六如.直壁矩形盒渐进成形技术[J].模具工业,2009,(5):40-43.
|
|
Service：
|
|
【This site has not yet opened Download Service】【Add
Favorite】
|
|
|
|
Copyright Forging & Stamping Technology.All rights reserved